Matte Gold Rhinestone Link Bracelet Component Set for 2mm Round Leather

Matte gold rhinestone link bracelet component set for 2mm round leather. Use this 4 piece set to create a stunning bracelet. Sets include rhinestone link, 2 sliders and a magnetic clasp.

Leather NOT included. Pick from our wide variety of colors in 2mm round leather.

To make a bracelet like the one pictured you will need the following:

• Approximately 50 inches of 2mm leather
• A toothpick – this helps to get the glue into the clasp. 

Directions are as follows:

1.  Cut four (4) pieces of leather at 10 inches long each.
2. Take two (2) of the 10 inch pieces and fold them in half.
3. Make a Larks Head knot around one side of the rhinestone focal component.
4. Repeat steps 2 and 3 for the other side of the focal component. 
5. Trim the leather on both sides to desire length. Keep in mind that you will need to account for the clasp in the length.  
6. Add a small amount of glue to one end of the clasp and tuck all 4 pieces of one side into the clasp. Hold to make sure it is secure.
7. Repeat step 6 on the other side. 
8. Wait until the glue is fully cured before wearing.